Smart Wave Maker
MCP
、
MLW
、
MOW Series
Mode selection and setting Time period setting
Linkage mode setting ： In the device control interface,
click "Linkage" button to enter linkage settings. In the linkage
mode, two or more wave pumps are required in a group. One pump
is set as the main control and the other slave control. When set the
function, only adjust the main control function, the slave control
function is determined by the main control.The main control has
timing and manual functions, and the settings are the same as
timing and manual settings.
To Next Page
Loading...
Need help?
General
