(5) Install the intercooler outlet hose to the vehi-
cle.
(6) Fill the reservoir and check the power steering
system for leaks.
PULLEY
REMOVAL
(1) Open the hood and disconnect the negative bat-
tery cable.
(2) Remove the intercooler outlet hose from the
vehicle.
(3) Remove the accessory drive belt from the power
steering pump pulley. Refer to Cooling System for the
procedure.
(4) Install a allen wrench in the power steering
pump center shaft to hold the pump in position.
Remove the (3) power steering pump pulley retaining
bolts (Fig. 3).
(5) Remove the power steering pulley.
INSTALLATION
(1) Install the power steering pump pulley on the
pump. Torque the retaining bolts to 27 N·m (20 ft.
lbs.). Use the allen wrench to hold the pump from
rotating.
(2) Install the accessory drive belt on the power
steering pump pulley. Refer to Cooling System for the
procedure.
(3) Install the intercooler outlet hose on the vehi-
cle.
(4) Connect the negative battery cable.
HOSES
REMOVAL
REMOVAL - PRESSURE HOSE - PUMP TO THE
HYDRAULIC FAN MODULE
(1) Drain the power steering fluid from the reser-
voir.
(2) Raise and support the vehicle.
(3) Remove the metal skid plate.
(4) Disconnect the high pressure hose from the
hydraulic fan motor.
(5) Lower the vehicle.
(6) Disconnect the high pressure hose from the
power steering pump.
(7) Remove the hose from the clipped position on
the fan shroud.
(8) Remove the hose from the vehicle.
REMOVAL - RETURN HOSE - RESERVOIR TO
THE HYDRAULIC FAN MODULE
(1) Drain the power steering fluid from the reser-
voir.
(2) Remove the battery.
(3) Remove the front fascia. Refer to the body sec-
tion.
(4) Remove the power steering reservoir. Refer to
reservoir removal in this section.
(5) Disconnect the rubber return hose from the
power steering reservoir.
(6) Raise and support the vehicle.
(7) Remove the metal skid plate.
(8) Disconnect the rubber return hose from the
hydraulic fan motor.
(9) Remove the hose from the vehicle.
REMOVAL - PRESSURE HOSE - GEAR TO THE
HYDRAULIC FAN MODULE
(1) Drain the power steering fluid from the reser-
voir.
(2) Remove the battery.
(3) Remove the battery tray.
(4) Remove the front fascia. Refer to the body sec-
tion.
(5) Remove the power steering reservoir. Refer to
reservoir removal in this section.
Fig. 3 Installing Power Steering Pump Pulley
1 - POWER STEERING PUMP
2 - ALLEN WRENCH HOLDING PUMP CENTER SHAFT
3 - POWER STEERING PUMP PULLEY
WG PUMP 19a - 3
RESERVOIR (Continued)
To Next Page
Loading...
