(2) Install 2 lower generator mounting bolts finger
tight (Fig. 2). Note lower bolts are slightly shorter
than upper bolts.
(3) Connect generator field wire connector to rear
of generator.
(4) Install B+ output cable nut and cable to rear of
generator.
(5) Install bolt at air conditioning line support
bracket (Fig. 4).
(6) Install oil pan splash shield. Press in 2 clips
(Fig. 3).
(7) Lower vehicle.
(8) Install 2 upper generator mounting bolts.
Tighten all 4 mounting bolts
(9) Tighten idler pulley bolt.
(10) Install turbo intercooler hose (Fig. 1).
(11) Install accessory drive belt by relieving ten-
sion on belt tensioner. Refer to Cooling System for
procedure.
(12) Connect negative battery cable.
GENERATOR DECOUPLER
PULLEY
DESCRIPTION
The generator decoupler is used only with
certain engines. The decoupler is used in place of
the standard generator drive pulley (Fig. 5).
OPERATION
The generator decoupler is used only with
certain engines. The decoupler (Fig. 5). is a one-
way clutch designed to help reduce belt tension fluc-
tuation, vibration, reduce fatigue loads, improve belt
life, reduce hubloads on components, and reduce
noise. Dry operation is used (no grease or lubricants).
The decoupler is not temperature sensitive and also
has a low sensitivity to electrical load. The decoupler
is a non-serviceable item and is to be replaced as an
assembly.
Fig. 3 OIL PAN SPLASH SHIELD
1 - OIL PAN SPLASH SHIELD
2 - SPLASH SHIELD CLIPS
Fig. 4 AC LINE AT OIL PAN
1 - OIL PAN (RIGHT/FRONT)
2 - MOUNTING BOLT
Fig. 5 GENERATOR DECOUPLER PULLEY
(TYPICAL)
WG CHARGING 8Fa - 3
GENERATOR (Continued)
To Next Page
Loading...
