OIL PUMP
REMOVAL
REMOVAL
(1) Disconnect negative battery cable.
(2) Remove oil pan (Refer to 9 - ENGINE/LUBRI-
CATION/OIL PAN - REMOVAL).
(3) Unbolt oil pump from crankcase.
(4) Press chain tensioner off oil pump chain and
remove oil pump (Fig. 32).
REMOVAL- OIL PUMP CHAIN
(1) Disconnect negative battery cable.
(2) Remove oil pan (Refer to 9 - ENGINE/LUBRI-
CATION/OIL PAN - REMOVAL).
(3) Remove oil pump (Refer to 9 - ENGINE/LU-
BRICATION/OIL PUMP - REMOVAL).
(4) Using special tool #8948, position and fit chain
seperating tool and thrust spindle onto a link of the
oil pump chain (Fig. 33).
(5) Screw the thrust pin in and seperate the oil
pump chain link.
(6) Remove pressed - out oil pump chain pin from
chain seperation tool.
CAUTION: IT IS ESSENTIAL that the installation pro-
cedure for the oil pump chain is followed exactly.
Failure to do so will result in severe engine dam-
age.
INSTALLATION
INSTALLATION
NOTE: Clean strainer of oil pump. If oil pump is dry,
fill with appropriate engine oil.
(1) Position oil pump and install oil pump chain.
(2) Install oil pump and seal.Tighten bolts to
18N·m (159 lbs. in.).
(3) Install oil pan (Refer to 9 - ENGINE/LUBRI-
CATION/OIL PAN - INSTALLATION).
(4) Fill crankcase to proper level with correct
engine oil. Refer to owners manual for specification.
(5) Reconnect negative battery cable.
WARNING: USE EXTREME CAUTION WHEN ENGINE
IS OPERATING. DO NOT PUT YOUR HANDS NEAR
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE
CLOTHES.
(6) Start engine and inspect for leaks.
Fig. 32 OIL PUMP ASSEMBLY
1 - OIL PUMP CHAIN
2 - OIL PUMP CHAIN TENSIONER
3 - O-RING
4 - OIL PUMP
Fig. 33 OIL PUMP CHAIN LINK REMOVAL
1 - VIBRATION DAMPER/PULLEY
2 - OIL PUMP CHAIN
3 - SPECIAL TOOL #8948
9a - 42 ENGINE WG
To Next Page
Loading...
