Keyless Enter-N-Go — Passive Entry — If
Equipped
The Passive Entry system is an enhancement
to the vehicle’s Remote Keyless Entry system
and a feature of Keyless Enter-N-Go. This
feature allows you to lock and unlock the
vehicle’s door(s) without having to push the
key fob lock or unlock buttons.
NOTE:
• Passive Entry can be enabled or disabled.
Refer to “Uconnect Settings” in “Multime-
dia” in the Owner’s Manual on
www.jeep.com/en/owners/manuals for fur-
ther information.
• If wearing gloves on your hands, or if it has
been raining/snowing on the Passive Entry
door handle, the unlock sensitivity can be
affected, resulting in a slower response
time.
• If the vehicle is unlocked by the Passive
Entry Door Handle, and no door is opened
within 60 seconds, the vehicle will re-lock
and if equipped, the security alarm will
arm.
• The key fob may not be able to be detected
by the vehicle keyless-go system if it is
located next to a mobile phone, laptop or
other electronic device; these devices may
block the key fob’s wireless signal and pre-
vent the keyless-go system from starting
the vehicle.
To Unlock From The Driver's Side
With a valid Passive Entry key fob within 5 ft
(1.5 m) of the driver's door handle, grab the
front driver door handle to unlock the driver's
door automatically.
NOTE:
If “Unlock All Doors 1st Press” is pro-
grammed, all doors will unlock when you grab
hold of the front driver’s door handle. To
select between “Unlock Driver Door 1st
Press” and “Unlock All Doors 1st Press,”
refer to “Uconnect Settings” in “Multime-
dia” in your Owner’s Manual at
www.jeep.com/en/owners/manuals/ for fur-
ther information.
Grab The Door Handle To Unlock
19
To Next Page
Loading...
