• Push the OK button to access/select the
information screens or submenu screens of
a main menu item. Push and hold the OK
arrow button for two seconds to reset
displayed/selected features that can be
reset.
Instrument Cluster Display Selectable
Items
The instrument cluster display can be used to
view the following main menu items:
NOTE:
Depending on the vehicles options, feature
settings may vary.
•
Speedometer
• Stop&Start–If
Equipped
•
Vehicle Info
•
Audio
•
Driver Assist
•
Messages
•
Fuel Economy
•
Screen Setup
•
Trip
•
Settings
NOTE:
Refer to your Owner's Manual on
www.jeep.com/en/owners/manuals for further
information.
TRIP COMPUTER
The Trip computer is used to display informa-
tion on car operation when the key is turned
to the RUN position.
This function allows you to define two sepa-
rate trips called “Trip A” and “Trip B” where
the car's "complete trips" are monitored in an
independent manner.
Both trips can be reset (reset - start of a new
trip). To perform a reset, push and hold the
OK button on the steering wheel controls.
“Trip A” and “Trip B” are used to display the
figures relating to:
• Distance Travelled
• Average Consumption
• Travel Time (driving time)
Quantities Displayed
Distance Travelled
• Indicates the distance travelled by the start
of the new trip.
Average Consumption
• Represents the average fuel consumption
since the start of the new trip.
Travel Time
• Elapsed time since the start of the new trip.
OK Button
Short Push Of The Button: display of various
parameters.
Long Push Of The Button: reset quantities
and begin a new trip.
New trip
Starts after reset:
• "Manual" by pushing the OK button.
• "Automatic" when the "distance" reaches
the value is 62140 (99999.9 km) or when
the "time travel" reaches the value of
999.59 (999 hours and 59 minutes).
• After each disconnection and reconnection
of the battery.
GETTING TO KNOW YOUR INSTRUMENT PANEL
70
To Next Page
Loading...
