Fog Lights — If Equipped
The fog light switch is located in the multifunction
control lever. To activate the fog lights, turn on the
park/turn lights, low beam headlights, or “Auto”
headlights and pull out the end of the multifunction
control lever. A light in the instrument cluster shows
when the fog lights are on.
NOTE: Turning on the high beam headlights turns off
the fog lights.
A front fog light is a lighting device providing illumina-
tion forward of the vehicle under conditions of fog, rain,
snow, or dust. Principally, the front fog light supplements
the lower beam of a standard headlight system.
NOTE: Proper aim and adjustments of the front fog
lights should be made to prevent excessive glare for other
drivers.
Turn Signals
Move the multifunction control lever up or down and the
arrows on each side of the instrument cluster will flash to
show proper operation of the front and rear turn signal
lights. You can signal a lane change by moving the lever
partially up or down.
Turn Signal Auto-Mode
Tap the multifunction control lever once and the turn
signal (left or right) will flash three times, and automati-
cally turn off.
High Beam Switch
Push the multifunction control lever away from you to
switch the headlights to high beam. Pull the lever to-
wards you to switch the headlights back to low beam.
136 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
