EasyManua.ls Logo

Jeep commander 2008 - Cleaning the Rear Park Assist System; Rear Camera - if Equipped; Turning the Rear Camera on

Jeep commander 2008
493 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cleaning The Rear Park Assist System
Clean the Rear Park Assist Sensors with water, car wash
soap and a soft cloth. Do not use rough or hard cloths. Do
not scratch or poke the sensors. Otherwise, you could
damage the sensors.
REAR CAMERA IF EQUIPPED
Vehicles with a Navigation radio may be equipped with
a rearview camera (located on the rear liftgate) that
allows you to see an on-screen image (on the navigation
radio screen) of the rear of your vehicle, whenever the
vehicle is put into REVERSE.
WARNING!
Drivers must be careful when backing up even when
using the rear camera system. Always check carefully
behind your vehicle, and be sure to check for pedes-
trians, animals, other vehicles, obstructions, or blind
spots before backing up. Failure to do so can result in
serious injury or death.
If snow, ice, mud, or anything else builds up on the
camera lens. Clean the lens, rinse with water, and dry
with a soft cloth.
Turning the Rear Camera On
1. Select “Rear Camera” at the Systems Settings screen
and press ENTER. Refer to your “Navigation User’s
Manual” for detailed operating instructions.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 165
3

Table of Contents

Related product manuals