Jeep Compass Repair Manual

Back to Index
11. From the remaining replacement part, cut a 19mm strip from both the inner and outer rail. Clip
off the weld flanges, top and bottom, and dress edges. These pieces will be the weld-backer.
12. Prepare welding equipment per the weld chart at the end of procedure.
13. Install the weld-backers into the frame rail, centering them on cut edge. Clamp and tack the
weld in position when proper fit is confirmed.

Jeep Compass Specifications

General

Brand	Jeep
Model	Compass
Category	Automobile
Language	English