Jenn-Air WW30430P User Manual

Lists specific Jenn-Air electric wall oven models included in this service manual.

Senses internal temperature. Resistance decreases as temperature increases. Includes probe chart.

Provides switch contact for electronic control system. Simple set of two contact surfaces.

Programmable software component controlling oven, clock, and timer functions.

Uses electrostatic field to detect key press, drawing capacitance energy.

Displays time, temperature, and functions. Acts as input from membrane switch.

Contains intelligence for electronic control, controls oven functions, and has relays.

Monitors internal oven temperature. Resistance increases with temperature. Includes sensor chart.

Built-in codes to assist technician in diagnosing control system errors. Lists faults F1, F3, F9.

Step-by-step instructions for removing the oven door from the appliance.

Procedure for disassembling and servicing the oven door, including glass and trim.

Instructions for accessing and removing the control panel assembly.

Procedure for removing and replacing the oven door hinge assembly.

Instructions on how to access the cooling fan for servicing.

Steps for removing the oven sensor from the oven cavity.

Procedure for removing the bake element from the oven cavity.

Procedure for removing the broil element from the oven cavity.

Instructions for replacing or accessing the oven light bulb and socket.

Steps to access and remove the convection motor assembly.

Procedure for removing the oven vent and smoke eliminator.

Instructions for removing the oven cavity liner from insulation and structure.

Procedure for accessing and removing oven hinge pockets.

Diagram showing parts of the standard control panel assembly.

Diagram showing parts of the control panel assembly for JJW models.

Diagram showing parts of the oven door assembly.

Diagram showing parts of the oven door assembly for JJW models (upper & lower).

Diagram showing parts of the internal controls assembly.

Procedure to access the test mode by holding the stop time key.

Procedure to exit test mode by pushing the cancel key or auto-termination.

Performing test mode by pushing keypad and testing output response.

Procedures for temperature offset and clock/temperature changes on the electronic control.

Steps to access and perform diagnostic tests on the electronic control unit.

Schematic diagram illustrating the electrical connections for the W2451 model.

Schematic diagram illustrating the electrical connections for the W27100 model.

Schematic diagram illustrating electrical connections for multiple specified models.

Schematic diagram illustrating electrical connections for multiple specified models.

Schematic diagram illustrating the electrical connections for the WW2460 model.

Schematic diagram illustrating electrical connections for multiple specified models.

Schematic diagram illustrating the electrical connections for the WW27210 model.

Schematic diagram illustrating electrical connections for multiple specified models.

Schematic diagram illustrating electrical connections for JJW and JMW models.

Schematic diagram illustrating electrical connections for JJW models.

Schematic diagram for Canada models JJW8530 and JJW9530.

Schematic diagram for Canada models W27200*C and W30100*C.

Schematic diagram for Canada model WW27430*C.