POWER
Amplifiers
Testing
Before finishing the installation, perform the
following
tests to make sure the
wiring is correct and everything is operating properly.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Test Power Wiring
Turn
on
the receiver, but do not turn up the volume. The amplifier power light
should come on.
If
not, check the REM and +12V (B+) wires. Turn up the
receiver volume slightly.
All
speakers should operate.
If
not, check wiring
connections
at
amplifier and speakers.
Test Speaker Connections
These tests make sure the speakers are connected properly. If
speakers don't
play at
all,
one (or both) speaker wires may be disconnected.
9
Remote
Input
Level
Control
The Power 2000.10
comes equipped with a Remote
Input
Level Control.
Tre
Remote
Input
Level Control
allows
the input level to be adjusted from an
alternate location. It
can be mounted under-dash or in-dash. When the
amplifier is used to drive subwoofers and the low pass crossover is activated,
the Remote
Input
Level Control can be used as a
"remote
bass level
control".
This enables you to control the bass level independent from the rest
of
the
system. This is convenient for system tuning and/or when playing many
different types
of
music.
The Remote
Input
Level Control uses a 3.5mm modular cable for connectivity.
Simply
plug the 3.5mm modular cable into the amplifier and then into the
Remote
Input Level Control to activate the circuit.
0
INPUT
REMOTE
GA
IN
LPF
SUB BASS PHASE OUTPUT
0
SONIC BOOST -
ooooo~Q
,
MIN
MM
(
CIHz
~Z
101i.l
oiOtf>
Od8
•
tdl
1a8' 0•
0
OR
0
To Next Page
Loading...
