Jensen A530 - Greasing Instruction A530

Greasing Instruction A530
Greasing instructions for 8-working-hours-shift
Pos. No. Designation Frequency of lubrication Quantity
Quantity of lubricant,
strokes of grease gun
1 Main shaft bearing
free of maintenance
2
free of maintenance
2 Spur gears
free of maintenance
1 SAE 85 W 140
3 Joint
weekly
2 2-3, Retinax A
4
Bearing and
bearing guidance
daily
1 2-3, Retinax A
If your machine is equipped with a turntable, lubricate it monthly (Retinax A), until
the grease get´s out of the gap.
Both bearings of main shaft (pos.1) are filled with lithium-grease including anti-corrosive
of penetration class 3. On normal working conditions this is sufficient for the lifetime of
the bearing.
The bearing must not be regreased to avoid substantiel decrease of lifetime of bearings.
Be carefull !
If you clean the machine with a high pressure cleaner, take care that water does
not reach the bearings. This could lead to lubrication loss!
2
3
1
4