Jensen JBS-200 - Getting Started; Setup and Power Connection; Battery Installation

E-8
GETTING STARTED
ACCESSORIES
INCLUDED
Carefully
remove
the
unit
and
all
accessories
from
the
package.
Please
verify
that
you
have
all
the
following
accessories
before
recycling
the
gift
box.

Main
Unit

2
x
Speakers

User
Manual

Remote
control
Connecting
the
Speakers
Each
speaker
cable
has
a
plug
on
the
end
that
fits
into
the
speaker
connector
located
on
the
back
of
the
main
unit.
Make
sure
the
little
tab
on
the
top
of
the
plug
is
facing
up
when
inserting
it
into
the
connector.
The
plug
goes
in
only
one
way,
so
do
not
force
the
plug
into
the
connector
or
it
may
cause
damage.
POWER
SOURCE
This
unit
operates
on
120
VAC
~
60
Hz
AC
household
current
and
requires
one
CR2025
3V
lithium
battery
(included)
for
the
remote
control.
Do
not
attempt
to
operate
the
unit
from
any
other
power
source.
You
could
cause
damage
to
the
unit
and
void
your
warranty.
AC
Power
Connection
Plug
the
AC
power
cord
into
an
available
120V~
60Hz
AC
Outlet.
Make
sure
the
plug
is
securely
inserted
into
the
AC
outlet.
Installing the Batteries for the Battery Back-Up
1. Remove the battery compartment door located on the bottom of the main unit.
2. Follow the polarity markings inside the battery compartment, and insert 2 x AAA batteries (not
included) into the two battery slots located in the battery compartment.
3. Replace the battery door.
NOTES:
 When replacing the back-up batteries, do not disconnect the AC power cord from the wall outlet. If you
do, all the current date time and alarm settings will be erased.

If the unit will be left unplugged for a long period of time, remove the batteries to avoid any damage that
may occur if the batteries leak and cause corrosion.
Remote
Control
The
remote
control
operates
on
one
CR2025
3V
lithium
battery
(included
in
the
remote).
To
activate
the
remote
control,
remove
the
insulator
tab
inserted
in
the
battery
compartment.
If
the
remote
operation
becomes
intermittent
or
unsatisfactory,
replace
the
original
battery
with
a
new
CR2025
3V
lithium
battery.
1.
Press
down
on
the
compartment
cover,
slide
out
the
battery
holder
from
the
remote
control
case.
2.
Replace
the
battery
making
sure
the
battery
is
installed
correctly.
The
remote
will
not
work
if
the
battery
is
installed
with
the
wrong
polarity.
CAUTION:
1.) Danger of explosion if the battery is replaced incorrectly.
2.) Replace only with the same or equivalent type battery.
3.) Insert the battery holder back into the battery slot.
NOTE:
Only use a well-known brand of battery to ensure the
longest life and best performance.