Jensen POWER JPA1000D User Manual

JPA600D/JPA1000D
Amplifier Installation
& Operation Manual
JPA600D/JPA1000D
Manual de Instalación y Operación
JPA600D/JPA1000D
Manual de Installation et Operation
Contents
Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Wiring. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Indicators and Controls . . . . . . . . . . . . . . . . . . 11
Testing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Remote Bass Control . . . . . . . . . . . . . . . . . . . . 14
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . 15
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Contenido
Introducción . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Características . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Instalación. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Cableado. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Indicadores y Controles . . . . . . . . . . . . . . . . . .11
Pruebas. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13
Control Remoto de Nivel . . . . . . . . . . . . . . . . . .14
Localización de Problemas. . . . . . . . . . . . . . . .15
Especificaciones . . . . . . . . . . . . . . . . . . . . . . . .16
Garantía. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
Table des matières
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Dispositifs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Câblage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Indicateurs et contrôles . . . . . . . . . . . . . . . . . . 11
Preuves . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Commande à distance de niveau. . . . . . . . . . . 14
Localisations de problèmes. . . . . . . . . . . . . . . 15
Spécifications . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Garantie . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17

Jensen POWER JPA1000D Specifications

General

Amplifier Class	D
Channels	1
Bass Boost	0-12dB
Bass Boost Frequency	45 Hz
Low Pass Crossover	40 Hz - 180 Hz
Power Output (Max)	2000W
Input Sensitivity	200mV - 6V
Dimensions	11.25" x 10.5" x 2.5"
RMS Power @ 2 Ohms	1000W
THD at RMS Output	0.1%
Subsonic Filter	15Hz
Fuse Rating	30A
RMS Power @ 4 Ohms	500 Watts

Summary

Introduction and Warranty

Before You Begin

Guidance on safe listening practices and pre-installation considerations.

Warranty Service Information

Details on how to obtain warranty service, requiring the original dated receipt.

Amplifier Features

Installation Guide

Supplies and Tools Needed for Installation

Lists necessary tools, supplies, and adapters for amplifier installation.

Installation Safety and Preparation

Battery Disconnection and Mounting

Procedures for safely disconnecting the battery and choosing a mounting location.

Routing Wires Safely

Guidelines for properly routing wires to avoid damage and ensure correct connections.

Wiring and Charging System

Charging System Considerations

Guidance on upgrading your vehicle's charging system for amplifier power.

Power Wiring Guidelines

Recommended wire gauges for connecting amplifier power supply.

Wiring Connections and Fuses

Details on connecting power, remote, ground terminals, and fuse replacement.

Speaker Wiring Options

Illustrates options for connecting one, two, or four subwoofers, emphasizing correct polarity.

Input Wiring and Connectivity

Details RCA input, preamp/crossover setup for single/multiple amplifiers.

Connecting Multiple Amplifiers

Indicators and Controls Overview

Power Indicator and Input Level Control

Visual indicator for amplifier status and control for matching radio output to amplifier input.

Bass EQ Adjustment

Continuously adjustable bass boost control from 0 to +18dB @ 45Hz.

Advanced Controls and Protection Features

Details on phase, low pass filter, subsonic filter, standby, thermal, and overload protection.

Testing Procedures

Reconnect Battery and Test Power Wiring

Steps to reconnect battery and verify power wiring is functioning correctly.

Test Speaker Connections

Ensures speakers are properly connected and playing.

Remote Bass Control

Troubleshooting Guide

Technical Specifications

Limited Warranty Information