E-4
GETTING STARTED
POWER SOURCE
This DIGITAL AM/FM STEREO ARMBAND RADIO operates on 2 ‘AAA’ (UM-4)
batteries (not included).
INSTALLING BATTERY
1. Remove the BATTERY DOOR.
2. Following the polarity diagram (+ and -) shown in
the battery compartment (#10), insert 2 'AAA'
(UM-4) batteries (not included).
3. Close the BATTERY DOOR.
Note:
•
Replace the batteries when the LOW BATTERY INDICATOR (#16) show on the
LCD display and flash.
•
When changing batteries, you will lose the time and your presets.
•
For better performance and longer operating time, we recommend the use of
alkaline-type batteries
BATTERY
WARNING
1. Be sure that the batteries are installed correctly. Wrong polarity may damage the
unit.
2. (a) Do not mix old and new
batteries.
(b) Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
3. If the unit is not to be used for an extended period of time, remove the batteries.
Old or
leaking
batteries can cause damage to the unit and may void the
warranty.
4. Do not dispose of batteries in fire, batteries may explode or
leak.
5. Do not try to recharge batteries not intended to be recharged; they can overheat
and rupture.( Follow battery manufacturer’s directions ).
6. Dispose the old batteries in accordance with the local regulation.
USING THE BELT CLIP
The supplied BELT CLIP allows you to attach the SAB-55A on your belt for
convenient use.
1. Attaching the BELT CLIP
2. Removing the BELT CLIP
To Next Page
Loading...
