EasyManua.ls Logo

Jensen vm9311ts - User Manual

Jensen vm9311ts
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Instruction Manual
Manual de Instrucciones
Guide d'instructions
VM9311TS

Questions and Answers

  • J
    Jessica NormanSep 23, 2025
    Why can't I see video and photo media on TFT screen of Jensen vm9311ts Car Receiver?
    • A
      Amanda Harper MDSep 23, 2025
      If you cannot see video and photo media on the TFT screen of your Jensen Car Receiver, the iPod video settings might be incorrect. Change the iPod video settings to TV Out = On and check the Media Module yellow RCA video input cable.
  • T
    Tammy RiggsAug 23, 2025
    What to do if there is no/low audio output from Jensen vm9311ts?
    • J
      Jasmine EllisAug 23, 2025
      If you're experiencing no or low audio output from your Jensen Car Receiver, there could be several reasons. First, check the wiring and correct any improper audio output connections. Also, make sure the volume isn't set too low and increase it if necessary. Review the wiring diagram and check the “MUTE” connection. Damaged speakers can also cause this issue, so consider replacing them. Ensure the channel balance isn't heavily biased; if it is, adjust it to the center position. Finally, check if speaker wiring is in contact with any metal parts of the car and insulate the connections if needed.
  • U
    uwilliamsonAug 25, 2025
    Why is the image flashing or showing interference on my Jensen vm9311ts screen?
    • M
      Mary WhitneyAug 26, 2025
      A flashing image or interference on your Jensen Car Receiver screen can occur if the DVD is not compatible with the current TV system settings. Change the setup to accommodate the disc. It may also be caused by improper video signal connections, so check the wiring and correct it if necessary.
  • D
    Donald ConradAug 27, 2025
    How to troubleshoot poor sound quality or distortion on Jensen vm9311ts Car Receiver?
    • F
      Frederick WatsonAug 27, 2025
      Poor sound quality or distortion on your Jensen Car Receiver can be caused by several factors. If you are using a pirated disc, use an original copy instead. Ensure that the speaker power rating is compatible with the unit; if not, connect proper speakers. Finally, check the speaker contact to ensure the speaker is not shorted.
  • T
    Timothy MorenoAug 27, 2025
    What to do if my Jensen Car Receiver remote control does not function?
    • D
      David Silva IVAug 27, 2025
      If your Jensen Car Receiver remote control isn't working, the battery might be depleted. Replace it with a new one. Also, check if the battery is installed incorrectly; if so, remove it and install it correctly.
  • N
    Norman WilkinsonSep 17, 2025
    Why does 'ANTENNA' appear on the XM main screen of Jensen vm9311ts Car Receiver?
    • D
      davidglassSep 17, 2025
      If “ANTENNA” appears on the XM main screen of your Jensen Car Receiver, the antenna may not be connected. Check the satellite antenna connection.
  • D
    Diane StoutSep 14, 2025
    Why is there no sound on Jensen vm9311ts?
    • J
      John JohnsonSep 14, 2025
      If there is no sound on your Jensen Car Receiver, it may be due to incorrect cable connections. Check the RCA cables.
  • C
    Carlos BakerSep 15, 2025
    Why is XM source not available on Jensen vm9311ts Car Receiver?
    • M
      Matthew BrownSep 15, 2025
      If the XM source is not available on your Jensen Car Receiver, it could be due to incorrect cable connections. Check the XM Data cable or Media Module Cable.
  • J
    Jason HuntSep 6, 2025
    What to do if Jensen Car Receiver monitor stops at incorrect position?
    • L
      Lisa HaneySep 6, 2025
      If the monitor on your Jensen Car Receiver stops at an incorrect position, the moving path is likely blocked. Press the OPEN key to restart the monitor movement.
  • J
    Jack HinesSep 3, 2025
    Why is there no image on my Jensen Car Receiver?
    • B
      Bryan AllenSep 3, 2025
      If there is no image on your Jensen Car Receiver, it could be due to an incorrect connection to the parking brake wire. Check the wiring and correct it. Also, if PRK SW is activated and the parking brake is not engaged, stop the vehicle in a safe place and apply the parking brake.

Summary

CONTROLS AND INDICATORS

Button Operation

Explains the function of each button on the front panel of the VM9311TS unit.

OPERATING INSTRUCTIONS

Core Operations

Explains basic functions like power, mute, source selection, and volume adjustment.

SYSTEM SETUP MENU

General Setup Configuration

Configuration options for radio, clock, screen saver, and video format settings.

TUNER OPERATION

DVD;VCD VIDEO OPERATION

Playback Control and Features

Details on controlling playback, sectional repeat, random playback, and navigating menus/chapters.

DVD;DISC SETUP MENU

DVD Setup Configuration Options

Explains settings for language, video, audio, and parental lock for DVD playback.

DVD;DISC AUDIO OPERATION

MP3;WMA File Playback

Guidelines for playing MP3 and WMA files, including format and compatibility.

IPOD OPERATION

iPod Mode Access and Music Control

Steps to access iPod mode and control music playback using the unit or remote.

TROUBLESHOOTING

General and TFT Monitor Problems

Solutions for common unit power, remote, audio, and TFT monitor issues.

SPECIFICATIONS

Component and System Specifications

Detailed technical specifications for the receiver's amplifier, tuner, player, monitor, and general features.

Jensen vm9311ts Specifications

General IconGeneral
Resolution800 x 480 pixels
TouchscreenYes
DVD PlayerYes
BluetoothYes
USB Port/InputYes
SD Card SlotYes
Radio TunerAM/FM
NavigationNo
Backup Camera InputYes
Video OutputYes
Audio OutputRCA
Audio Output Power50W x 4
SiriusXM ReadyYes
Power Output50W x 4
Display Size6.2 inch

Related product manuals