Why is there no audio from my Jensen Car Receiver?
C
Christie RowlandJul 31, 2025
If you are experiencing no or low audio output from your Jensen Car Receiver, there are several potential causes. First, check the wiring to ensure proper audio output connection. Next, verify that the volume is not set too low and increase it if needed. Also, review the wiring diagram to check the “MUTE” connection. Damaged speakers can also cause this issue, so consider replacing them. Additionally, ensure that the channel balance is not heavily biased to one side by adjusting it to the center position. Finally, make sure that the speaker wiring is not in contact with any metal parts of the car, and if it is, insulate the connections.
D
Doris PeckAug 5, 2025
How to fix Jensen Car Receiver that won't turn on?
M
morgancookAug 5, 2025
If the Jensen Car Receiver unit will not power on, it could be due to a blown fuse. Check the radio fuse and the car battery fuse, and if either is blown, install a new fuse with the correct rating. If the issue persists, press the RESET button located in the bottom right corner of the front panel to address any illegal operation issues.
C
Courtney BruceAug 10, 2025
What to do if my Jensen Car Receiver remote control does not function?
R
rosskellyAug 10, 2025
If the remote control for your Jensen Car Receiver is not functioning, the first thing you should check is the battery. If the battery is depleted, replace it with a new one. If that doesn't solve the problem, remove the battery and reinstall it correctly, ensuring it is properly aligned.
E
emccormickAug 15, 2025
Why is the sound quality poor on my Jensen Car Receiver?
R
Rita BradyAug 15, 2025
If you're experiencing poor sound quality or distortion with your Jensen Car Receiver, there are a few things to consider. First, if you are using a pirated disc, switch to an original copy. Second, ensure that the speaker power rating is compatible with the unit; if not, connect proper speakers. Finally, check the speaker contact to ensure the speaker is not shorted.
B
Brittany MorrisAug 20, 2025
What to do if there is no image on my Jensen Car Receiver?
M
Marissa BakerAug 20, 2025
If you are not getting an image on your Jensen Car Receiver screen, the issue might be related to the parking brake. First, check the wiring to the parking brake wire and correct it if necessary. If the wiring is correct, ensure that the parking brake is engaged by stopping the vehicle in a safe place and applying the parking brake.
W
Wendy DavidsonAug 25, 2025
Why is there a flashing image on my Jensen Car Receiver screen?
J
John BeckerAug 26, 2025
If you observe a flashing image or interference on the screen of your Jensen Car Receiver, it could be due to the DVD not being compatible with the current TV system settings. Try changing the setup to accommodate the disc. Additionally, check the video signal connections to ensure they are properly wired and correct any improper connections.
To Next Page
General
