Jensen VM9314 - Mute and Line Mute; Playing Source Selection

VM9314
Mute/Line Mute
Press the rotary encoder button (1) on the front panel orthe MUTE button (3)
on the remote to mute the volume from the unit. Press the rotary encoder
button again to restore the volume. "MUTE" is displayed on the LCD. Adjusting
the volume or using any
of the audio setup features cancels the mute function.
Ifthe "MUTE" wire is connected, audio output mutes when a telephone call is
received by the car phone (using optional BTM15) or when verbal navigation is
played (using optional NAV102).
Playing Source Selection
When the monitor is closed, press the SRC button on the front panel (2) or
remote control (8) to change between available audio playing sources in the
following order: RADIO, DISC, USB/iPod, SD,
BT, NAV, SAT, AUX1, AUX2 and
CAMERA. The mode is displayed on the LCD screen.
Source Menu
You can also use the touch screen to change the source through the SOURCE
MENU.
To access the SOURCE MENU, touch the top left corner of the screen
or press the SRC button on the front panel (2) or remote control (8).
@ SOURCE MENU
@
r@J
CV
®
®
RADIO DISC USB/lPod SO
BT
~
@
®
~
NAV
SAT
AUX1
AUX2
CAMERA
1;;;1
II "Q
e
Touch the RADIO, DISC, USB/iPod, SD, BT, NAV, SAT, AUX1 , AUX2 or
CAMERA button to select the corresponding source.
You can also use voice control to select a source. See "iPod Voice Control" on
page 19.
NOTE: When an iPodliPhone is attachedto the USB port, "/POD"
appears instead
of the text "USBliPod. "
15