Optional
Equipment
• NAV102: Allows you to access navigation features. All installation and operating instructions are included
with the navigation module.
• BTM15: Allows you to connect to a Bluetooth enabled cell phone
or
other device.
• Rear Camera
Disconnecting
the
Battery
To
prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to in-
stallation.
NOTE:
If
the VM9314 is to
be
installed in a
car
equipped with
an
on-board drive ornavigation computer,
do
not disconnect the battery cable.
If
the cable is disconnected, the computer
memory
may
be
lost.
Under
these
conditions, use extra caution during installation to
avoid
causing a short circuit.
Pre-installation
CAUTIONI Be careful
not
to damage the
car
wiring.
D
II
II
Remove the four screws that attach the mounting sleeve to the
radio and remove the sleeve.
Install the mounting sleeve.
a.
Install mounting sleeve into the dashboard or optional
adapter. Do not force the sleeve into the opening or cause
it to bend or bow.
b.
Locate the series
of
bend-tabs along the top, bottom and
sides
of
the mounting sleeve. With the sleeve fully insert-
ed into the dashboard opening, bend as many of the tabs
outward as necessary so that the sleeve is firmly secured
to the dashboard.
c.
Install support strap to make the unit more stable.
Place the radio in front
of
the dashboard opening so the wiring
can be brought through the mounting sleeve.
2
..
..
,.
DASHBOARD
To Next Page
Loading...
