2. Roll
Raise the rollback handle and the deck will slide back. Roll the deck
rearward approximately 12 inches to clear the mechanical hold downs at
the front of the frame. A decal is provided on the rubrail to aid in
determining the amount to roll. Align the decal pointer with the red control •
handle. _
4. Roll
Raise the roll handle and the deck will slide back. Continue this operation
until the approach plate has contacted the ground.
Make sure that the rear bumper and the approach plate are both in firm
contact with the ground before unloading. There should be an equal
weight distribution between the rear bumper and the end of the deck.
&.
2
Q~."'.
..••
_-
-----
ManaUYUI
••c.c~nc
•
5. Winch
Securely tighten the winch cable and finish unbinding the load. Winch off
the load (See winch operating instructions). Store the winch cable by
fastening the hook to the deck and winching the cable taut
CAUTION: Remain clear of load when unbinding and winching off the
deck.
fiJ ~~
Rev. _
•
2.5
Oale _
Eastern Wrecker Sales Inc
To Next Page
Loading...