•
19. Install safety pin to Insure
mechanism does not drop In
the event of a hydraulic failure.
20.
Allach the salety chains and
magnetic towing lights.
16. Raise the vehicle into the final
towing position observing the
far end for sufficient ground
clearance. It is possible to set
the rear of a Irontlifted vehicle •
completely onto the ground,
causing damage. Take
irregular roadsurfaces into
consideration. Observe the lift
function from the side and
away from both vehicles If
possible.
17. Power retract the grid boom
until the towed vehicle is about
3 to 4 feetlrom the back 01the
truck. Leave enough room to
maneuver around corners
without corner binding or
causing contact between the
two (2) vehicles. Be sure that
the boom Is extended at
least 4" to Insure unob-
structed crossbar pivoting. •
18. Be sure to maintain sufficient
clearances with the bollom of
the towed vehicle.
~
4"
~1\~II
.b)
n~
r
,-
Revo _
2.11
Dale _
Eastern Wrecker Sales Inc
To Next Page
Loading...