INSTALLING THE TIE DOWN STRAP
•
2. Set the rachet spool in "free
spool' position and pull the
webbed strap out and form a
loop which will wrap around
fhe tire. Be sure the loop is
over approximately 1/3 of the
tire.
4. Raise the wheel grid to the
towing position. RE.TIGHTEN
THE RACHET PERIODICAL-
L Y
AS TIRE SETTLES IN
GRID FROM TOWING
1. With the vehicle lifted just
barely off the ground. attach
the strap to the wheel grid. Be
sure the rachet pin is secured •
with the hairpin cotter pin.
/ I 3. Take up the slack In the strap
by reattaching the takeup
spool arm. Continue until the
tires show some compression.
•
Rev. _
2.13
Dale _
Eastern Wrecker Sales Inc
To Next Page
Loading...