1 888 275 4538 MVP GROUP .24 | P a g e
2- Verify if the rinse aid container is empty. If yes, fill it with rinse aid product. (see par. 2D)
3- Verify the quality and the quantity of the rinse aid used and check with the assistance service. (see par.
2D)
4- Verify the rinsing temperature is between 80°C (176°F) to 90°C (194°F) degrees.
CONDENSATION ON GLASSES?
1- Verify if the rinse aid container is empty.
If yes, fill it with rinse aid product. (see par. 2D)
2- Verify the quality and the quantity of the rinse aid used and check with the assistance service. (see par.
2D)
3- Remove the glasses from the rack immediately after the end of each cycle.
STAINS ON GLASSES?
1- Use only non-foaming products for professional dishwashers.
EXCESSIVE FOAM IN THE TANK?
1- Verify washing water temperature is not less than 50°C (122°F) degrees.
2- Ask the assistance service to verify the instruction for the rinse aid dosing. (see par. 2D)
3- Ensure the tank has not been cleaned with unsuitable cleaners. Drain the tank and rinse thoroughly
before new wash cycles.
4- If foaming detergent has been used, drain and refill the tank with water until the foam disappears.
SMEARS OR SPOTS ON THE GLASSES?
1- Ask the assistance service to verify the instruction for the rinse aid dosing.
EMERGENCY
IN CASE OF FIRE A POWDER EXTINGUISHER MUST BE USED.
IN CASE OF DANGER CUT-OFF IMMEDIATLY THE ELECTRICITY AT THE BREAKER PANEL.
The Manufacturer reserves the right to modify the appliances presented in this publication without notice.
To Next Page
Loading...
