5
Work must be mounted on the
press securely. Do not use the
press with work mounted at an
angle.
The press is designed for pressing,
broaching, bending and
straightening purposes only.
Always make sure the ram
contacts the workpiece squarely
before applying pressure.
Some parts may have a tendency
to pop out of the press or explode
under pressure. Protect yourselves
accordingly.
KEEP HANDS AND FINGERS
clear of the pressing area in front
and rear of the ram.
WEAR SAFETY GLASSES.
Support long work pieces with
helping roller stands.
Sheet metal stock has sharp
edges.
WEAR GLOVES when handling
sharp edged work pieces.
7. Adjustments
If ram is loose and falls by itselves,
snug bolts (B). All four bolts should
be tensioned equally.
8. Maintenance
Lubrication:
The machine must be lubricated
every day of service.
Oil the pinion through the oil port
(D).
Grease ram rack (A).
Lubricate all slide and pivot points
of the machine.
Lightly oil the machined parts
when not in use to prevent rust.
9. Environmental protection
Protect the environment.
Your appliance contains valuable
materials which can be recovered
or recycled. Please leave it at a
specialized institution.
To Next Page
Loading...
Need help?
General
