Jet JBC Series - User Manual

OWNER’S MANUAL
JBC Series Beam Clamps
 WARNING
• Read and understand all warnings and operating instructions before attempting to use the beam
clamp.
• Beam clamps are designed and intended for use on “I” and “H” beams having an installed rated
value of the beam clamp.
• NEVER install a beam clamp on a beam that has not been rated or tested for attachment of lifting
devices.
• Beam clamp must be fully tightened and fully engage beam before use.
• Beam clamps are designed for vertical lifts only. DO NOT use for side or angle pulls or lifts.
• Always replace worn, damaged or missing labels.
Failure to comply with these warnings may result in personal injury and/or property damage.
JET P.O. BOX 1349 Phone: 253-351-6000
WMH Tool Group Auburn, WA 98071-1349 Fax: 1-800-274-6840
www.jettools.com e-mail jet@wmhtoolgroup.com M-252710 6/02

Summary

JBC Series Beam Clamps Owners Manual

General Warnings and Safety Instructions

Critical safety precautions and operating guidelines for using the beam clamp. Ensure proper installation and use.

Parts List for JBC Series Beam Clamps

Jet JBC Series Specifications

General

Type	Band Saw
Motor Power	1 HP
Table Tilt	45 degrees
No-load Speed	3000 RPM
Chuck Size	Not applicable