What to do if the chuck or arbor does not stay in place on my Jet JWDP-12?
If the chuck or arbor does not stay in place on your Jet Power Tool, clean all mating surfaces thoroughly with a cleaner degreaser to remove any dirt, grease, etc. from the arbor, chuck, or spindle.
What to do if my Jet Power Tool drill press will not start?
If your Jet Power Tool drill press won't start, there are several potential causes: * The drill press might be unplugged. Ensure all plug connections are secure. * A fuse may be blown or a circuit breaker tripped. Replace the fuse or reset the circuit breaker. * The cord could be damaged. If so, replace the cord. * The starting capacitor might be bad, requiring replacement.
Why does my Jet JWDP-12 Power Tool workpiece burn while drilling?
If your workpiece burns while using the Jet Power Tool drill press, consider the following: * The speed might be incorrect. Change to the appropriate speed. * Chips may not be clearing from the hole or bit. Retract the drill bit frequently to remove chips. * The drill bit could be dull. Resharpen or replace the drill bit. * The feed rate might be too slow. Increase the feed rate.
Why is my Jet JWDP-12 drill press noisy?
Noisy operation of your Jet Power Tool drill press can be due to several factors: * Incorrect belt tension. Adjust the belt tension. * Dry spindle. Lubricate the spindle. * Loose spindle pulley. Check the tightness of the retaining nut on the pulley and tighten if necessary. * Loose motor pulley. Tighten the set screws in the pulleys.
What causes excessive drill bit run out or wobble in my Jet JWDP-12?
Excessive drill bit run out or wobble in your Jet Power Tool can be caused by: * A bent drill bit. Replace the drill bit. * Worn spindle bearings. Replace the spindle bearings. * Improperly installed bit or chuck. Reinstall the bit or chuck properly.
Why does my Jet Power Tool drill press vibrate so much?
Excessive vibration in your Jet Power Tool drill press can be attributed to: * The stand being on an uneven surface. Adjust the stand so that it rests evenly on the floor. * Bad belts. Replace the belts.
What causes my Jet JWDP-12 Power Tool drill bit to bind in the workpiece?
If the drill bit binds in the workpiece while using your Jet Power Tool, it could be due to: * The workpiece pinching the bit. Support or clamp the workpiece. * Excessive feed rate. Decrease the feed rate. * Chuck jaws not tight. Tighten the chuck jaws. * Improper belt tension. Increase the belt tension.
How to prevent wood splintering on the underside when using a Jet JWDP-12 Power Tool?
To prevent wood splintering on the underside when using your Jet Power Tool, place a scrap board beneath the workpiece.
Why does my Jet JWDP-12 Power Tool drill press not come up to speed?
If your Jet Power Tool drill press does not reach its full speed, it could be due to: * An extension cord that is too light or too long. Replace it with a cord of adequate size and length. * Low current. Contact a qualified electrician.
Why does my Jet Power Tool drill bit wander?
If your Jet Power Tool drill bit wanders, possible causes include: * The bit being sharpened incorrectly. Resharpen the bit correctly. * A bent drill bit. Replace the drill bit. * The bit or chuck not being installed properly. Reinstall the chuck or bit properly.
Instructions for connecting the base and column of the drill press.
Details on how to install the table and rack assembly onto the drill press column.
Essential guidelines for properly grounding the drill press to prevent electric shock.
General| Brand | Jet |
|---|---|
| Model | JWDP-12 |
| Category | Power Tool |
| Language | English |
To Next Page
