6
5.0 Unpacking
Read and understand all
assembly instructions before attempting
assembly. Failure to comply may cause serious
injury.
Separate all parts from the packing material. Check
each part against sect. 5.1, Contents of shipping
container and make certain that all items are
accounted for before discarding any packing
material.
5.1 Contents of shipping container
Refer to Figures 1 and 2.
1 Head Assembly – A
1 Table – B
1 Table Arm & Support Assembly – C
1 Base – D
1 Column and Rack Assembly – E
4 Handles – F
1 Arbor – G
1 Drift Key – H
1 Chuck Key – J
2 Lock Handles – K
1 Owner’s Manual
1 Warranty Registration Card
Hardware
4 M10 x 25 Hex Cap Screws – N
1 Chuck – O
2 Table Extension Lock Knobs – P
1 Table Height Adjust Handle – Q
Tools supplied for assembly
1 3mm Hex Wrench – L
1 4mm Hex Wrench – M
Additional tools required: 5/8” Wrench
Before Assembly
1. Remove contents from shipping container.
2. Compare contents of shipping container with
the list found above. Report any shortages or
damage to your JET distributor.
3. Clean all rust protected surfaces with kerosene
or a light solvent. Do not use lacquer thinner,
paint thinner, or gasoline. These will damage
plastic components and painted surfaces.
Figure 1: contents of shipping container
Figure 2: Additional contents
To Next Page
Loading...
