7
6.0 Assembly
6.1 Base and column assembly
Refer to Figure 3:
1. Place base (D) on a level floor.
2. Place column assembly (E) on base (D) and align
holes in column support with holes in base.
3. Using a 5/8-in wrench, secure column (E) with
four M10 x 25 hex cap screws (N) to the base.
6.2 Table and rack
Refer to Figure 4:
Note: If table arm/support assembly (C) and rack (E
3
)
are already installed on column (E), proceed to step 4.
Otherwise, begin with step 1.
1. Remove rack ring (E
1
) and rack (E
3
) from column
(E). Note which end of the rack is up. It must be
reinstalled later with the same side up.
2. Place rack (E
3
) inside table support (C) such that
the teeth of the rack (E
3
) mesh with the pinion
gear on the end of the table crank handle shaft
(C
1
).
3. Slide table arm/support assembly (C) together
with the rack (E
3
) onto the column (E) as shown.
4. Place rack ring (E
1
) onto column (E), sliding it
down so it rests against rack (E
3
) as shown, and
tighten setscrew (E
2
) with a 3mm hex wrench
(provided).
5. Place table (B) onto table arm (C), positioning it
as shown in Figure 4. Secure table with lock
handle (K).
6. Secure table extension (B1) with two table
extension lock knobs (Q).
6.3 Table height adjust and lock
handles
Refer to Figure 4:
1. Loosen the setscrew (R
1) on the table height
adjust handle (R).
2. Slide the handle (R) onto the table bracket shaft (C
1).
3. Turn the handle (R) until the setscrew (R1) is on
the flat section of the shaft (C1) and tighten the
setscrew (R1) with a 3mm hex wrench to secure
the handle.
4. Thread the column lock handle (K) into the back
side of the table bracket (C) opposite the height
adjust handle (R).
Figure 3
Figure 4
To Next Page
Loading...
Need help?
General
