To Next PageTo Next PageWhy is there no coolant flow in my Jet Saw?
If there is no coolant flow in your Jet Saw, it could be due to: * Coolant level low: Add coolant to tank. * Filter screen clogged: Clean filter screen. * Pump motor faulty: Replace pump.
How to fix inaccurate miter cuts on a Jet Saw?
Inaccurate miter cuts on your Jet Saw may be due to: * Improper setting of vise jaws: Use adjustable square or protractor to verify angle settings. * Blade worn; cutting crooked: Replace blade.
Crucial warning emphasizing the need to read the entire manual before assembly or operation.
Critical warning about the necessity of installing the red blade guard after blade replacement.
Critical warning regarding the risks and requirements for performing blade tracking adjustments.
Critical safety warning about securing the bow before loading material and avoiding starting cuts with blade contact.
Critical safety warning against loading/unloading during operation and holding workpieces by hand.
Critical warning to disconnect power before performing any maintenance to prevent serious injury.
General
