Jet JDP-17 - Specifications Overview; Motor and Electrical Specifications

6
5.0 Specifications
Model number ............................................................................................................................................... JDP-17
Stock number ................................................................................................................................................ 716300
Motor and electricals:
Motor type ............................................................................ totally enclosed fan cooled, induction, capacitor start
Horsepower ............................................................................................................................................... 3/4 HP
Phase......................................................................................................................................................... single
Voltage ................................................................................................................................................. 115V only
Cycle ........................................................................................................................................................... 60Hz
Listed FLA (full load amps) .............................................................................................................................. 9 A
Starting amps ............................................................................................................................................... 18 A
Running amps (no load) .................................................................................................................................. 3 A
Start capacitor ............................................................................................................................. 150μF, 125VAC
Run capacitor ................................................................................................................................ 40μF, 250VAC
Power transfer ................................................................................................................................. 2 poly v-belts
On/off switch .......................................................................................... push button with safety key, paddle stop
Motor speed ........................................................................................................................................ 1720 RPM
Power cord ....................................................................................................................... 16 AWG, 6 ft. (183 cm)
Power plug installed ........................................................................................................... 115V, 15A with ground
Recommended circuit size
1
.......................................................................................................................... 15 A
Sound emission ...................................................................................................... 80dB at 39” (1m) without load
Laser system ............................................................................................................................................ Class II
Head and Capacities:
Swing
2
....................................................................................................................................... 16-7/8” (430mm)
Chuck style and shank capacity ..............................................................................................keyed, 5/8” (16mm)
Chuck arbor taper .............................................................................................................................JT-3 to MT-2
Spindle taper ............................................................................................................................................... MT-2
Spindle travel, maximum ....................................................................................................................5” (127 mm)
Spindle travel per one revolution of handle .........................................................................................5” (127 mm)
Quill diameter ................................................................................................................................. 2.05” (52 mm)
Number of spindle speeds................................................................................................................................ 16
Maximum no-load speed range ..................................................................................................210 to 3500 RPM
Maximum spindle to table distance ................................................................................................... 29” (740 mm)
Maximum spindle to base distance ........................................................................................... 46-1/2” (1180 mm)
Maximum chuck to table distance ............................................................................................... 25-1/4” (640 mm)
Maximum chuck to base distance ............................................................................................. 42-1/2” (1080 mm)
Work lamp ....................................................................................................................... integrated, pivoting LED
Depth stop type ........................................................................................................................................ internal
Materials:
Head ...................................................................................................................................................... cast iron
Table ............................................................................................................................ precision-ground cast iron
Table insert .................................................................................................................................................. MDF
Column ........................................................................................................................................................ steel
Base ...................................................................................................................................................... cast iron
Table:
Table size ............................................................................................................... 14” L x 19” W (356 x 483 mm)
Table slots (4)......................................................................................................... 3-1/8”L x 5/8” W (79 x 15 mm)
Table T-slots (2) ...................................................................................................... 1/2” W x 5/8” D (13 x 15 mm)
Distance between T-slots (centers)............................................................................................. 10- 5/ 8” (270 mm)
Table tilt ...................................................................................................................................... 90 deg. L and R
Table rotation around column .................................................................................................................. 360 deg.
Table elevating system .......................................................................................................... worm gear with rack
Table insert ............................................................................................................... 3-3/4” x 3-3/4” (95 x 95 mm)
Recommended maximum weight on table ........................................................................................ 66 lb. (30 kg)
1
Subject to local and national electrical codes
2
Swing is twice the distance from column to spindle center (i.e., the maximum diameter of workpiece that can be
drilled to its center).