Power Feed Operation (JMD-18PFN only)
1. Set the power feed speed range dial (A, Fig. 14)
to the desired rate.
2. Set the depth stop to the desired setting by
lowering the quill to the desired depth and
holding in place. Turn the collar (8, Fig. 14)
counter-clockwise until zero is indicated and
then tighten the lock handle (C, Fig. 14)
3. Start the mill/drill and pull one of two handles(D,
Fig. 14) away from the column to start the power
downfeed.
4. Once the downfeed has reached the depth stop,
the trip will release and the spindle will retract.
5. To stop the feed before the cycle has ended or
to disengage the fine feed (E, Fig. 14), press one
of two handles toward the column.
Note: For best results, all milling operations
should be done with the quill/spindle as close to
the head assembly as possible. Lock spindle
and table in place before starting milling
operations.
Fig. 14
11
To Next Page
Loading...
