Jet JMD-18 - Preparation and Setup; Shipping Container Contents; Unpacking and Tools

Contents of the Shipping Container
1 Mill/Drill
Accessory Package:
1
1
1
1
2
Chuck Arbor (installed)
1/2" Drill Chuck w/ Chuck Key
Adjustable Carbide Facemill
Facemill Arbor
Bolts, Nuts, and Washers to
Attach Vise to Table
2-1/2" Angle Vise (JMD-15)
3-1/2" Angle Vise (JMD-18/18PFN)
Handle Rods
Plastic Knobs
3/8"x1" Hex Socket Cap Screw
3/8" Washer
Crank Body
Crank Handle
3mm Hex Wrench
5mm Hex Wrench
23mm Hex Socket Wrench (JMD-18/18PFN)
Hand Wheels w/ Handles
Can Touch-Up Paint
Operator's Manual
Warranty Card
1
1
3
3
1
1
1
1
1
1
1
3
1
1
1
Unpacking and Clean-up
1. Finish removing the crate from the mill/drill.
Unbolt the machine from the crate bottom.
Report shipping damage, if any, to your
distributor.
2. Remove any protective coating with kerosene or
a mild solvent. Do not use gasoline, paint
thinner, or lacquer thinner. These will damage
painted surfaces.
Tools Needed for Assembly
8" Adjustable Wrench or 1/4" to 1-1/4" Combination
Wrench Set
4