it WARNING
1. Read and understand the entire
instruction manual before attempting
set-up or operation of this machine.
2. Always wear approved safety
glasses/face shields while using this
machine.
3. Make certain the machine is properly
grounded.
4. Before operating the machine, remove
tie, rings, watches, other jewelry, and roll
up sleeves above the elbows. Remove
all loose clothing and confine long hair.
Do not wear gloves.
5. Keep the floor around the machineclean
and free of scrap material, oil and
grease.
6. Keep machine guards in place at all
times when the machine is in use. If
removed for maintenance purposes, use
extreme caution and replace the guards
immediately.
7. Do not over reach. Maintain a balanced
stance at all times so that you do not fall
or lean against blades or other moving
parts.
8. Make all machine adjustments or
maintenance with the machine
unplugged from the power source.
9. Use the right tool. Don't force a tool or
attachment to do a job which it was not
designed for.
10. Replacewarning labels if they become
obscured or removed.
11. Make certain the motor switch is in the
OFF position before connecting the
machine to the power supply.
12. Give your work undivided attention.
Lookingaround, carrying on a
conversation, and "horse-play" are
careless acts that can result in serious
injury.
13. Keepvisitors a safe distance from the
work area.
14. Use recommended accessories;
improper accessories may be
hazardous.
15. Keep hands away from all moving parts
(belts, cutters, gears, etc.).
16. Never operatethis machine under the
influence of alcohol or drugs.
17. Read and understandall warnings
posted on the machine.
18. This manual is intended to familiarize you
with the technical aspects of this milling
machine. It is not, nor was it intended to
be, a training manual.
19. This machine isdesigned and intended
for use by properly trained and
experienced personnel only. If you are
not familiar with the proper safe use of
milling machines, do not use this
machine until proper training and
knowledge has been obtained.
20. Failureto comply with all of these
warnings maycause serious injury.
2
To Next Page
Loading...
Need help?
General
