Jet SPACE BALLZ - Page 21

1) If you look up at Section # 3 - you will see four bolts that come off
the front of the main unit. When Section # 4 is installed - these bolts
will secure the unit in place.
2) There are two elongated holes in the upper part of Section # 3
where the tabs on Section # 4 will fit into place.
Locating the support tabs
The two tabs on Section # 4 will fit into the two holes on the top of
Section # 3.
Step # 6-A
Locating the bolts on section # 3
Check Box When This Step is Complete
Step # 6-B
INSTALLATION INSTRUCTIONS
Check Box When This Step is Complete
Locating the support holes
The two tabs on Section # 4 will fit into the two holes on the top of
Section # 3.
Check Box When This Step is Complete
Step # 6-C
1
2
Jennison Entertainment Technologies Space Ballz Service Manual Page 21