Jet SPACE BALLZ - Page 29

Check Box When This Step is Complete
Pull wires out of the main cabinet
Pull the wires out of the main cabinet and check that the pins in each
of the connectors are properly seated.
Check Box When This Step is Complete
Step # 9-B
Attach the wires from the control panel to the main cabinet
Attach the wires from the main cabinet (Section # 2) (If Applicable) to
the wires in Section # 1. Each connector is marked or numbered to
the corresponding connector.
Step # 9
Pull the wires out of the control panel
Pull the wires out of the control panel and inspect each connector.
Ensure that all pins are properly seated in the connectors.
Check Box When This Step is Complete
Step # 9-A
INSTALLATION INSTRUCTIONS
Jennison Entertainment Technologies Space Ballz Service Manual Page 29