JETI model Duplex REX Series User Manual

computer radio control system
PPM neg.- standard form of PPM signal generation with
negative logic at PPM outputs. The bus idle state is log.1.
PPM input - for the given input there a PPM signal is expected
from the connected receiver
JETIBOX EX - telemetry sensor connection or data stream for
JETIBOX
EX Bus/EX Bus HS - digital communication, when transmits
throw and telemetr y information with configuration
possibilities of equipment connected to this bus, for instance by
a DC/DS transmitter. This configuration type is used, for
instance, when receivers are connected for example to Central
Box.
Serial UDI12/16 - serial data output suitable for connection of
devices with unidirectional UDI interface (e.g. Vbar).
PPM error code- in case of PPM input mode, an acoustic signal can
be set up to announce that this connected signal is missing. By
loading a character from the Morse alphabet you may set up tones
that will acoustically announce the absence of a PPM signal at the
given receiver output. This acoustical signal is generated by the
transmitter module. In the factory default setup the acoustical
signal is switched off.
SetInChannel - assignment of an actual output (labelled as Yx) or
input channel (labelled as Chx)
EN
16
®
User ManualUser ManualUser Manual
EN
Receivers REXReceivers REX
FW 1.00FW 1.00
Receivers REX
FW 1.00
COMPLEX RADIO CONTROL SYSTEM

JETI model Duplex REX Series Specifications

General

Brand	JETI model
Model	Duplex REX Series
Category	Receiver
Language	English