Care & Maintenance
CLEANING THE ADVENTURE
• Carefully wipe with a damp cloth and then dry with a dry cloth.
• Do not apply water directly to the Adventure, as the electrical and electronic systems may get wet, which could lead to
a malfunction that puts rider safety at risk.
BATTERY PRECAUTIONS
• Keep away from fire and excessive heat.
• Avoid intense physical impact and/or severe vibration.
• Protect from water or moisture.
• Do not disassemble.
• If there are any issues with the battery, contact the Jetson Care Team.
STORING THE ADVENTURE
• Remove batteries from rear light before storing.
• Cover to protect the bike from dust.
• Store indoors, in a dry place and at a suitable temperature.
MAKING CHAIN ADJUSTMENTS
• The chain must be at the correct tightness.
When the chain (C) is at the correct tightness, you can rotate the
crank freely and you can pull it no more than one-half inch (A) away
from a straightedge (B) as shown.
• If too tight, the bicycle will be diicult to pedal.
• If too loose, the chain can come o the sprockets.
Adjust the tightness of the chain as follows:
• Loosen the axel nuts on the rear wheel.
• Move the rear wheel forward or backward as necessary.
IMPORTANT: Always make sure the rear wheel is centered under the bicycle frame.
• Hold the wheel in this position and tighten the axel nuts.
C
B
A
WARNING:
Do not attempt chain repairs. If there is a problem with the chain, have a
bicycle service shop make any repairs.
To Next Page
Loading...
Need help?
General
