NUT
BOLT
STEM
PHILLIPS-HEAD
SCREWDRIVER TIP
5. INSERT THE BOLT THROUGH THE ALIGNED HOLES ON THE RIGHT-HAND SIDE OF THE HANDLEBAR UNTIL THE END OF
IT IS VISIBLE THROUGH THE LEFT-SIDE HOLES.
IMPORTANT: PLACE THE BOLT ON THE RIGHT SIDE WHEN FACING THE HANDLEBAR FROM THE RIDING POSITION.
6. PLACE AND HOLD THE NUT AT THE END OF THE BOLT, ENSURING THAT IT IS NESTLED IN THE HANDLEBAR HOLE.
7. TIGHTEN THE BOLT INTO THE NUT BY TURNING IT CLOCKWISE WITH THE SCREWDRIVER TIP OF THE 2-BIT TOOL.
8. CHECK THAT THE HANDLEBAR IS SECURE.
IMPORTANT: PRIOR TO EVERY RIDE, CHECK THAT THE BOLT AND NUT ARE TIGHTENED AND SECURE.
B
B
B
B
B
*AS VIEWED FROM RIDING POSITION
To Next Page
Loading...
