Jetson JETKART 2.0 - Assembly; Attaching Tire Bracket and Joysticks; Attaching the Seat

5
Assembly should take approximately 15 minutes.
ASSEMBLY
1. Place the Tire Bracket over the matching holes on the Foot Rest Frame.
2. Thread a large bolt and washer through each hole in the Tire Bracket, and attach a nut to the
other side. Attach the Tire to the Foot Rest Frame by tightening the nut using the included Wrench
and Allen Key.
3. Slide the Left Joystick onto the Seat Frame. Insert a large bolt and washer through, and tighten
using a nut and the included Wrench and Allen key. Repeat on the right side with the Right Joystick.