Jetson Plasma X - How to Recalibrate

13
1.6 How to Recalibrate
HOLD POWER BUTTON
FOR 5 SECONDS
FOLLOW THESE 4 SIMPLE STEPS:
1. POWER OFF THE PLASMA X AND PLACE IT ON A FLAT SURFACE.
ROTATE THE FOOT PADS SO THAT THEY ARE PARALLEL TO THE GROUND AND ALIGNED WITH EACH OTHER.
2. PRESS THE POWER BUTTON IN FOR 5 SECONDS. YOU WILL HEAR A SHORT MUSICAL TUNE.
3. WHEN THE TUNE IS COMPLETE, RELEASE THE POWER BUTTON AND THEN PRESS IT AGAIN TO POWER THE PLASMA X OFF.
4. TURN PLASMA X BACK ON; RECALIBRATION IS NOW COMPLETE.
* KEEP THE HOVERBOARD LEVELED AND STILL THROUGHOUT THE RECALIBRATION PR0CESS.
* WHILE RECALIBRATING, DO NOT LEAN ON OR PUT ANY WEIGHT ON THE HOVERBOARD.
* IT CAN TAKE UP TO 3 RECALIBRATION ATTEMPTS TO ACHIEVE PROPER INTERNAL ALIGNMENT.
YOUR HOVERBOARD'S INTERNAL BALANCE MECHANISMS SOMETIMES NEED TO BE RESET, OR "RECALIBRATED."