Page 19 | EN
|
E-Sub
EN
WARNING
CH. 2
(
R
)
Grounded
Isolated
CH. 1
(
L
)
HIGH LEVEL INPUTS
LINE
OUTPUTS
LL
RR
LINE
INPUTS
SUB
REAR
REAR CENTER
FRONT
FRONT
R
L
PRE OUT
E-SUB REAR PANEL
RECEIVER / PROCESSOR
E-SUB TOP CONTROL PANEL
SYSTEM CONNECTION DIAGRAM 1:
One E-Sub to Home Theater Receiver
or Home Theater Preamp/Processor
Most home theater receivers and
preamp/processors provide a single
(mono) subwoofer line-level output.
When connecting a mono subwoofer
output to your E-Sub, you only need
to connect to one of the E-Sub’s “Line
Inputs” (Left or Right). Use a good-
quality audio interconnect cable with
RCA-type connectors.
In most cases, you will use the bass
management/crossover features of the
receiver or preamp/processor. This
requires that the E-Sub’s “Crossover”
switch is placed in the “Off” position.
WARNING! TURN OFF THE E-SUB(S) AND ALL OTHER EQUIPMENT IN THE
SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
To Next Page
Loading...
