13
Maintenance
and safety
4
When carrying out maintenance operations, the
following requirements must be met:
Replacing the belt See figure 23
4.1
Never carry out maintenance operations with the
machine in operation.
Unplug the machine.
Strictly follow the indications in the manual.
Use original spare parts
3
1
2
4
To check the tightness of the belt or to replace, proceed
as follows:
Turn off the machine at the main switch and unplug it.
Undo the four screws securing the machine’s rear
protection.
Undo the four screws holding the motor in place.
Tighten or replace the belt.
To tighten the belt, push the motor towards the rear
of the machine and tighten the four screws securing
the motor.
To replace the belt, carry out the same operations as
for tightening but with a new belt.
3
1
2
4
5
6
Replacing the light See figure 24
4.2
To replace the light, proceed as follows:
Switch off the machine.
Release the fixing ring.
Remove the light and undo its wire.
Connect a new light to the wire, put it in its housing
and secure with the fixing ring.
3
1
2
4
Replacing fuses
4.3
If the machine does not start when switched on, check
the fuses:
To do this, proceed as follows:
Switch off and unplug the machine.
Remove the fuse-holder next to the main switch.
Check (using a tester) if a fuse has blown and, if so,
replace it with another identical one.
3
1
2
Safety recommendations
4.4
Do not try to start the machine or use it until all safety
aspects, installations instructions, operating guidelines
and maintenance procedures have been carried out and
understood.
Always unplug the machine before carrying out
maintenance or cleaning operations.
Always keep the machine and its surrounding area clean.
3
1
2
Accessories
5
A series of accessories are available.
Basic accessories
5.1
The machine is supplied with a series of accessories for
its use and maintenance:
Two fuses, two 3 and 2.5 Allen keys, two plates for end
stop, two F-1 / F-13 milling cutters and two P-1 / P-13
tracer points.
List of accessories for cutting certain
models of key
5.2
List of accessories:
Milling cutters and tracer points to be used to cut the
following keys:
See figure 25
English
To Next Page
Loading...
Need help?
General
