11
水平尾与机身对接
1
2
3
Docking the horizontal tail and the fuselage
①如图1所示，将水平尾上的孔位对应机身上的碳纤维管插入，并对接到位。
②对接到位后，在水平尾下表面有两个孔（图中绿色箭头），用2.5六角螺丝
刀插入，用适当的力拧紧即可。
① As shown in Figure 1, insert the hole on the horizontal tail corresponding to the
carbon fiber tube on the fuselage, and connect it in place.
② After docking, there are two holes on the lower surface of the horizontal tail (the
green arrow in the picture), insert it with a 2.5 hex screwdriver, and tighten it with
appropriate force.
To Next Page