EN-15
MAINTENANCE BY DISTRIBUTOR
We perform maintenance and inspections described below. Contact your supplier for more information.
Check the internal pressure adjustment accuracy and measurement accuracy with special jigs
and measuring instruments, and perform periodic adjustments and repairs.
REPLACEMENT FREQUENCY AND TIMING
Approximately 2,500 measurements
AA alkaline batteries or AA nickel-metal hydride rechargeable batteries
(two batteries at the same time)
※ Refer to page EN-9 for the replacement procedure.
DISPOSAL INFORMATION
WEEE (Waste Electrical and Electric Equipment) should not be disposed as general waste.
After using the device, dispose of it properly according to local or national regulations.
Tongue Pressure Prove is medical waste.
For other items, please refer to the following table and dispose it as general waste under
the instructions of local or national authorities.
Packaging
(common materials)
Cushioning material or individual packaging bag
Digital Tongue
Pressure Meter
Body (including operation buttons and battery cover)
Acrylonitrile-butadiene-styrene copolymer
General electrical parts, Stainless steel
Connecting tube connector
The Tongue pressure Probe is prohibited from being reused because it causes measurement errors and
infections.
When replacing batteries, replace two AA alkaline batteries or AA nickel-metal hydride rechargeable batteries
at the same time.
If the connecting tube becomes severely dirty or folded, it may cause measurement error. Replace the
connecting tube as needed.
To Next Page
Loading...