37
EN
TROUBLESHOOTING
PROBLEM LIKELY CAUSE SOLUTION
8. The blades do not
engage
9. Uneven cut and
poor grass collection
10. Unusual
vibrations while
working
11. Uncertain or
ineffective braking
12. Erratic forward
movement, poor dri-
ve when going uphill
or if the machine has
a tendency to rear up
13. With the engine
running, the machine
does not move when
the drive pedal is
pressed
– the safety devices have cut in
– problems with engagement
mechanism
– cutting deck not parallel to the
ground
– blade cuts badly
– forward speed too high compared to
the height of the grass ( 5.4.5)
– collector channel is blocked
– cutting deck is full of grass
– blades are unbalanced or loose
– bolts and screws are loose
– the brake is not adjusted correctly
– problems with the belt or the
engagement device
– move the disengagement lever to
position «B»
– check that the conditions allowing
starting are met ( 5.2.b)
– contact Your Dealer
– check the tyre pressure ( 5.3.2)
– realign the cutting deck ( 6.3.2)
– contact Your Dealer
– reduce forward speed and/or raise
the cutting deck
– wait for the grass to dry
– remove the grass-catcher and
empty the collector channel
( 5.4.7)
– clean the cutting deck ( 5.4.10)
– contact Your Dealer
– check and tighten all the engine and
frame bolts
– contact Your Dealer
– contact Your Dealer
– move it to position «A» ( 4.33)
If problems continue after having carried out these operations, contact your dealer.
Do not take on complicated repair work if you don't have the
necessary equipment or the technical knowledge. The warranty is automatical-
ly voided and the manufacturer is not held responsible if repairs are done
badly.
WARNING!
To Next Page
Loading...