For storage and transport purposes, some components of the machine are not
installed in the factory and have to be assembled after unpacking. Follow the instruc-
tions below.
The machine is supplied without engine oil or fuel. Before starting
the engine, fill with oil and fuel following the instructions given in the engine manual.
Unpacking and completing the assembly should be done on a
flat and stable surface, with enough space for machine handling and its packaging,
always making use of suitable equipment.
3.1 UNPACKING
When unpacking the machine, take care to gather all individual parts and fittings, and
do not damage the cutting deck when taking the machine off the pallet.
The packaging contains:
– the machine;
– the steering wheel;
– the seat;
– the front bumper (if provided);
– the battery;
– the grass-catcher (with instructions);
– an envelope containing:
– the instruction manuals and documents,
– nuts and bolts including a pin for locking the steering wheel,
– starter keys and a spare 10A fuse.
To prevent damage to the cutting deck, raise it to its maximum
height and take utmost care when taking the machine off the pallet.
On hydrostatic drive models: to make it easier to move or take the machine off the
pallet, put the transmission disengagement lever in position «B» ( 4.33).
Disposal of the packaging should be done in accordance with the local regulations in force.
NOTE
WARNING!
IMPORTANT
UNPACKING AND ASSEMBLY
9
EN
3. UNPACKING AND ASSEMBLY
To Next Page
Loading...