10
User guide
Power nozzle
• Lift up end of agitator brushroll. Re-
move old belt from agitator pulley ( F )
and replace with new belt. Lettering
on belt must be visible. Stretch belt
back and attach to motor pulley.
• Position hood on top of nozzle base.
• Turn nozzle over. Replace 2 short
screws at the back of nozzle and 2
long screws at the front.
• Hold opposite end of agitator
brushroll in place. Push belt end for-
ward, rotating end plate ( G ) until it
slides into place. Turn agitator, mak-
ing sure it rotates freely.
• Replace brushroll cover ( C ) over
agitator brushroll. Replace 3 short
screws.
• Lift off brushroll cover ( D ).
• Remove brushroll cover ( C ) by re-
moving the 3 Phillips head screws.
• If belt is not broken but is stretched
or cut, pull it off the motor pulley ( E ).
6- MAINTENANCE ( suite )
6.3
• Return nozzle to original position
and lift off hood.
• Disconnect power nozzle from ex-
tension wand.
• To remove hood, turn nozzle over
and unscrew the recessed Phillips
head screws.
Belt replacement
• The belt in your power nozzle drives
the agitator. II has been designed
specically for use in this cleaner and
is important for effective operation.
When to replace
• The belt should be checked from
time to time to be sure it is in good
condition. To check remove the hood
( see following section ).
How to replace
• Replace the bell if it is stretched,
cut, or broken.
To Next Page
Loading...
