JohnnyVac XV10 Plus - Troubleshooting

12
User guide
Problem Check Solution
Vacuum does
not turn ON
• Power cord
• Plug in power cord. Make sure it is rmly into the wall
outlet.
• Power source
• If no power to outlet, check power source, fuse or circuit
breaker.
• Hose connection • Make sure the hose is securely connected.
• Thermal protector • Allow vacuum to cool per instructions ( see page 6 ).
Vacuum has
little or no
suction
• Filter bag
• Filter bag may be clogged or full. Check and replace if
necessary ( see page 8 ).
• Motor lter
• May be dirty or clogged. Clean or replace if necessary
( see page 9 ).
• Hose, wand or
accessories may be
clogged
• Clear obstruction.
• Hose connection • Make sure hose is properly connected.
Power nozzle
won’t turn ON
• Hose power cord
• May not be properly connected. Plug hose rmly into
receptacle on nozzle.
• Belt
• Belt may be worn or broken. Check and replace if
necessary ( see page 10 ).
• Switches
• Make sure surface selector switch and/or brushroll switch
are both on ( see page 4 ).
• Thermal protector • Allow vacuum to cool per instructions ( see page 6 ).
Vacuum still
does not operate
properly
• Review all the above • Contact your dealer for service.
CHECK THESE FIRST
Service problems that appear to be major can often be solved easily. You can be your own troubleshooter
by reviewing this guide.
7- TROUBLESHOOTING