11
GLAS smart thermostat installation instructions -
©
2018 Johnson Controls
Installing your GLAS
8. Remove the liner over the air seal
adhesive and align the seal with the drill
holes on the back side of the GLAS
device. Lightly press to secure.
Note: If you are using the optional back
plate, secure between the wall and the
GLAS before screwing in the device.
9. Pull all of the wires through both the air
seal and terminal opening in the GLAS
smart thermostat. Press rmly on the
wires to push them through the air seal.
To Next Page
Loading...
