QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE OF 11 178
IQ BASE SPEAKER (OPTIONAL)
1. With a small phillips
screwdriver, undo the locking
screw from the back of the
panel, remove the SmartMount
backplate and discard.
1. Locate the IQ Base with
SmartMount and connect the
power cable from the IQ Base
into the BLACK connector
inside the IQ Panel 4. Refer to
Interior Diagram on Page 7
Insert the top hooks into the
back of the panel, then swing
down and press into place.
1. With a small phillips
screwdriver, screw in the
locking screw from the
bottom of the panel to
secure it to the IQ Base.
1. With the included power
supply and cable, plug the
barrel connector into the
barrel jack on the bottom of
the IQ Base as shown above.
Be sure the barrel is pushed
all the way in.
To Next Page
Loading...
